12
/
14
6. Offline controller
(Optional)
Note: The offline controller and the computer cannot be connected to the engraving machine at the same time. When
using the offline controller, please make sure that the USB cable of the machine and the computer is disconnected
.
6.1 Main page:
Y-
: right
Y+
: left
Z+
: Send $X to the GRBL motherboard to unlock it.
OK/SPN
: Confirm button.
6.2 Control page:
Manually move each axis to the desired position.
X+
: X axis move right direction,
X-
opposite.
Y+
: Y axis move forward direction,
Y-
opposite.
Z+
: Z axis move up
direction,
Z-
opposite.
OK/SPN
: Spindle test switch, press to open the spindle (corresponding to SPN gray on the screen), press again to close
the spindle (the corresponding SPN on the screen returns to normal). Long press to enter changing spindle speed page.
At this page, Y+/Y- is High/Low spindle speed, long press OK/SPN to exit the changing spindle speed page.
Exit/STP
: Function 1: Tap on each axis button of XYZ to change the movement distance by 0.1, 1, 5, 10 cycles each time.
Function 2: Press and hold for about 2 seconds to exit.
6.3 File page:
File list Select the file to be engraved. Support documents include: NC, NCC, TAP, TXT, Gcode, GCO, NL, CUT, CNC .
Y+
: up,
Y-
: down
OK/SPN
: Confirm the selection and enter the confirmation engraving page.
6.4 Confirm the engraving page:
Confirm that the engraving file is started without errors.
S3018 Pro Ver 2.3
