VETRON 5000, Инструкция по эксплуатации

Страница: 50 / 83

1
2
4
3
48
07/2020
VETRON 5000/5100 - FLAT BED MACHINE - INSTRUCTION BOOK
NR. PARAMETER DESCRIPTION
» TARGET STITCH FUNCTION
078 Target stitch position
ADVICE!
Parameter 078 can only be selected when the position of stitch placing
is activated in parameter 085 , 086 or 087 . The position of the needle
point above the material is set with this parameter.
05. PROGRAMMING
04. PROGRAM PARAMETER
-7-14
NR. PARAMETER DESCRIPTION
» PRESSER FOOT HEIGHT, PRESSER FOOT POSITION, NEEDLE POSITION
070
Foot lift height
The setting for the desired hight of presser foot lift is entered here (in mm)
for the program in question.
071 Foot lift maximum for operator You can restrict the maximum foot heigth (mm) for the operator here.
074 Foot position on stop
Two positions are available (Pedal in 0-position):
UP or DOWN .
075 Foot position on seam end
Two positions are available (Pedal in 0-position):
UP or DOWN .
077 Needle position on stop
Two positions are available (Pedal in 0-position):
POS1 or POS2 .
NR. PARAMETER DESCRIPTION
» ELECTRONIC RULER FOR EDGE DISTANCE (OPTIONAL)
060
Edge value
Following functions are available:
OFF = Edge ruler is deactivated.
0.1–35.0 mm = Edge ruler is activated (Edge distance e.g. 10 mm).
The distance from the needle to the edge can be entered directly in mm. It can´t
be set below the right edge of the presser foot. This setting can only be done by
a service technican.
066 Edge guide height adjustment The setting for the desired height of the 2-axial edge guide is entered here in %.