Vestax FADERBOARD, Руководство пользователя

Страница: 10 / 21

Essentially the User Defined Programs are onboard sample banks that you can use to record onto by using the various
input options (LINE, PHONO, MIC) available. There are ten (10) available banks to which a maximum of thirty (30)
seconds worth of samples can be recorded. These samples can be played back using the KEY FADERS, with each
KEY FADER playing back the original sample at a different pitch.
In addition to being able to record onboard, you can record additional samples through the FADERBOARD onto a
Smart Media Card.
There are a maximum of ten (10) User Definable sample banks. The total onboard recording space available cannot
exceed thirty (30) seconds.
・
・
・
・
・
Standby Mode. Push the REC SWITCH once to set the
sample function to standby. When in standby mode
the REC LED and the DISPLAY will flash. If you want to
exit from standby mode and NOT record, press either
the TONE or EWIT / + SWITCH.
Connect your external source, from which you want to
sample, to the FADERBOARD and select that input
using the INPUT SELECT SWITCH on the rear panel
of the FADERBOARD. There is 1 x LINE INPUT, 1 x PHONO
INPUT and 1 x MIC INPUT.
・
If using a turntable make sure your connection to
the phono terminal is also grounded. Use the GND
TERMINAL provided on the FADERBOARD.
・ In addition to any external source you can record a
sample from the onboard Synth Programs or Drum /
Percussion Programs.
・ It is also possible to record a sample of combined
external and internal sources.
INPUT LEVEL VOLUME. If you have connected an
external device make sure that you set the input level
correctly to avoid overload of the circuitry. The
SIGNAL / PEAK LED will flash if your input level is to
high. To adjust the input level use the INPUT LEVEL
VOLUME.
Begin Recording. Press the REC SWITCH again to
start recording your sample. When you are recording
a sample the REC LED will be illuminated and the
DISPLAY will flash.
End Recording. Press the REC SWITCH once more.
When this is done the SAVE LED will start flashing and
the DISPLAY will show an illuminated "U".
1. RECORDING A SAMPLE
USER DEFINED PROGRAM / SAMPLE
B
ANKS
REC LED : Flash DISPLAY : Flash
REC LED : Illuminate DISPLAY : Flash
SAVE LED : Flash DISPLAY : Illuminate
SMART MEDIA PARAMETER
SAMPLE
CONTROL
SAVE LOAD
REC MIDI
ENTER /
-
EXIT /
+
SAVE
TONE
TUNE / BPM
WAV
MIN MAX
I NPUT LEVEL
START POINT
END POINT
SIGNAL
/ PEAK
MIC I NPUT
PHONO I NPUT
GND TERMI NAL
REC S WITCH SAVE S WITCH SAVE LED
INPUT SE LECT S WITCH LINE I NPUT
REC LED
SIGNAL / PEAK LED
REC
REC
SAVE
INPUT LEVEL VOLUME
10
By ending the recording process you have managed to record a sample. This sample is not yet saved to a User
Defined Program bank. You can listen to your sample by using the KEY FADERS before you save it.