Setting the operation mode “awning/blind”
There are two operation modes (awning/blind) possible for the
Vestamatic
Markise Plus 500 V 2.0
sunshade control. The setting is
carried out with DIP switch no. 5 on the rear panel of the device.
DIP switch at OFF: Operation mode “awning”
Press the retract or extend button in order to retract or extend the
awning. The awning will automatically move up or down at once. The
motion can be stopped easily by pressing the opposite button.
DIP switch at ON:
Operation mode “blind”
Press the retract or extend button for 2 seconds in order to move the
blinds up or down. The blind will move up or down. Simply press the
opposite button to stop the motion. If you press the retract or extend
button for less than 2 seconds or tap it, the blinds will move up or
down only for the duration of the command which provides accurate
positioning and adjustment of the slat angle.
G
-
34 -
Start-up
After setting the operation mode, setting the wind speed threshold
and mounted the housing, you can power on the control.
Now the control starts up and indicates this by flashing the LED’s.
After this the sensors will be checked. Notice: For a complete wind
sensor test, the wind sensor must generate at least one impulse.
Maybe you must turn the wind speed sensor by hand. After this the
LED’s of the
Vestamatic
Markise Plus 500 V 2.0
sunshade control
change automatically into normal operating status.
Optional the LED’s indicate easy to understand the different status of
the sensors. For more information see page 48 and 49. Now set the
motor run time (see page 37) and if necessary the tilting time (see
page 39) of the sunshade and check the running direction with the
buttons on the front. After this set the response to the sun intensity
(see page 41). Now the
Vestamatic
Markise Plus 500 V 2.0
sunshade
control
is ready to control your sunshade.
G
-
33 -
