Operation without sun (manual operation)
Push the selector switch to the right to
disable the sun function (
##S
). If you
press the
retract or extend button,
the sunshade drives will retract or
extend the sunshade.
Simply press the opposite button to
stop the motion, i.e.:
·
press the
retract button, if the
awning is moving out,
·
press the
extend button, if the
awning is moving in.
Accurate positioning of sunshades is guaranteed because the sun-
shade will only move in or out after the
retract or
extend button has
been pressed.
Note:
A tilting function that was programmed with the DIP
switches will also be performed during manual operation.
Attention: If the wind velocity exceeds the preset value, extend-
ing the sunshade is not possible for safety reasons.
Also an extended sunshade will be retracted imme-
diately.
G
-
45 -
Sun sensor monitoring
Only if one sun sensor is connected, the cable connection and the
sun sensor will be checked continuously. In case of a failure, it will be
displayed by the LED’s. The control will be still operable. In case of a
defect the red sun sensor LED lights up with a short break (warning).
Now you have got to check the sun sensor or the wiring. In case of
connection a second sun sensor, the sun sensor monitoring will be
switched off automatically.
Keep in mind that working at the control is only permitted to pro-
fessional electricians.
G
-
46 -
