VESDA VLS-XXX, Руководство по эксплуатации продукта

Страница: 30 / 48

LaserSCANNER Product Manual
VESDA
®
22
Mounting the LaserSCANNER detector in Normal Orientation
Place the three bridges located at the rear of the detector onto the lances of the mounting
bracket. Push downwards until it locks onto the lances and engages the fitting dimples. To
prevent unwanted removal of the detector, secure the detector to the mounting surface by
placing two screws through the keyhole slots situated near the termination card.
Figure 11 - Mounting the LaserSCANNER onto the mounting bracket
Mounting the LaserSCANNER in the inverted orientation
If the detector is fitted with a LCD Programmer and/or a Display Module, reorient these to the
inverted position. Mount the detector in inverted orientation onto the mounting bracket.
Figure 12 - Mounting the LaserSCANNER detector in inverted orientation
onto the mounting bracket
Mounting the LaserSCANNER without mounting bracket
In the event the detector has to be mounted directly onto the mounting surface, remove the
chassis from the mounting box. See
Replacing the chassis/Air Inlet Pipe Manifold on page 32 for
details.
Use the four keyhole slots to secure the mounting box to a flat surface, ensuring that it is
horizontally straight. Re-install the chassis into the mounting box. Carefully re-connect the looms
and complete the cabling prior to closing the front cover. See “Internal Wiring for
LaserSCANNER” on page 34.