This is the property of Overview Limited, no copying without permission
except as permitted by copyright law
23 May 2013
9
Installation / Connection
Wall Mounting Bracket
1.
Using the base casting as a template, drill and fit wall plugs to the mounting surface. Fit and screw
the base casting to the mounting surface.
2.
The cable loom needs to be routed through the various mounting bracket components prior to final
assembly.
3.
Screw the cover to the base casting using the 4 x trilobular thread forming screws supplied.
4.
Fit the arm A keyholes slots over the M6 screw heads fitted to the cover, and then rotate to lock and
tighten the screws.
5.
Slide the plastic cover down the arm, align the two brass pegs in the base casting with the
corresponding holes in the plastic cover and push down.
6.
Attach the second arm B to the first arm and fit the two M6 screw and nut sets supplied.
7.
Before fitting the Dome, attach the safety cable to the eyelet on the end of arm B. Fit the Dome to
the bracket arm by aligning the keyhole slots with the M6 screw heads fitted to the Dome, rotate to
lock then tighten the screws.
8.
Slide the plastic cover down the arm and locate it as in point 5 above.
Cover
Plastic Cover
Arm A (without
eyelet)
Base Casting
Plastic Cover
Arm B (with
eyelet)
Safety Cable
Dome
Fig 1
