Vertiv™ XTE 601E Series Equipment Enclosures Description and Installation Manual
Proprietary and Confidential © 2022 Vertiv Group Corp.
63
13.
Supporting the front end of the batteries, install the short interconnecting strap across the terminals on the rear of Blocks 1-2.
Install the block end cover, and push both batteries to the rear of the shelf. Perform the same steps for Block 4-5.
NOTE!
Torque at 96 in-lbs and apply No-Ox to all exposed metal surface.
NOTE!
Keep battery handles upright for easier installation.
14.
Using a DMM, measure voltage between the (+) terminal of Block 1 and the (-) terminal of Block 2. Reading should be equal
to the sum of the two blocks’ total voltage. Perform the same step, measuring across the (+) terminal of Block 4 and the (-)
terminal of Block 5. See Figure 13.6.
Figure 13.6 Measuring voltage between the Blocks
15.
Install Block 3 (with long interconnect strap attached and insulated, with block end-cover installed) into the shelf; push to the
rear of the shelf.
NOTE!
Keep battery handles upright for easier installation.
16.
Carefully removing the insulating material from the long interconnect strap, use a DMM to measure voltage between the (+)
terminal of Block 3 and the end of the long interconnect strap. Reading should be equal to the Block 3 voltage.
17.
Using a DMM, measure the voltage between the (+) terminal of Block 4 and the end of the long interconnect strap connected
to Block 3. Reading should be 0VDC.
Block 1
(+) Terminal
Block 2
(-) Terminal
Block 5
(-) Terminal
Block 4
(+) Terminal
