Vertiv | VE Series Rack | User Manual
Installation Instructions
3.5.
Adjusting the Bottom Panel (optional)
In some VE series rack models, the standard three-section type bottom panel is an optional accessory. The adjustment
method of the three-section type bottom panel is as follows:
Adjust the area of the air inlet on the bottom of the rack according to the need. Move the three sections of the bottom
panel forward or backward to the required position, and use M5 self-tapping screws to fix them on the guide rails, as
shown in
Figure 3-12
.
Slide bottom panel
Guide rail
Self-tapping of M5
A
A amplified
Figure 3-12 Bottom Panel Adjustment
•
The bottom panel is divided into three segments, the front and two rear segments are identical, pay
attention to the difference while adjusting.
•
No trampling on the bottom panel.
3.6.
Removing the Front and Rear Door
Removing the Front Door
As shown in
Figure 3-13
, open the front door at 90° or at a larger angle (<135°), then lift the front door up to
approximately 15mm, then pan it to the right approximately 50mm, and remove the front door.
1
2
Front door
Front door
Figure 3-13 Remove the Front Door Schematic (Front Door Open)
