Vertiv | VE Series Rack | User Manual
Pre-Installation Preparation
2.4.
Unpacking
The procedure to open the packaged rack is as follows:
1.
Move the packaged rack to a horizontal open, firm ground.
2.
Inspect whether the rack of assembled package has any obvious damages during transportation. If any
damage is found, please contact the carrier immediately.
3.
Use a utility knife to remove the extension film wrapper on the rack.
Removing the Pallet
2000mm and 2253mm height rack are fixed in the same ways on the pallets by using pallet fixtures.
Pallet disassembly for Racks with castors and feet:
Loosen the M6 combination screws and M10 bolts on the pallet fixture with a hexagonal sleeve wrench and remove the
pallet fixture as shown in
Figure 2-7
.
Fixtures of pallet
Fixing screw of M10(4 pcs)
Fixing screw of M6
（
6 pcs
）
Figure 2-7 Disassembly of Pallet Fixtures
The procedure to remove the pallet is as follows:
1.
Place a wooden board of about 1200mm on the pallet.
2.
Slide the rack carefully towards the wooden board from the rear of the pallet through the caster and feet of the
rack, then slide slightly to the ground, as shown in
Figure 2-8
.
