Vertilux VTi 6-710-VB-00110, Инструкция по программированию

Страница: 7 / 20

6
vertilux.com
© 2019. Vertilux, Ltd. All Rights Reserved. Last revised: February 2019.
2. Press and hold the blue button until you reach
step 4.
TILTING MOTOR
BLUE BUTTON
3. On the wall control, press either direction
button . If the button you pressed does not make
the carriers rotate, try the opposite
direction button . Press the stop button when the
carriers are aligned and set at 0° of the track
(fully closed position) (fig. 5) *.
Remember which direction button you selected in
this step.
DIRECTION BUTTON STOP BUTTON
TILTING MOTOR
RED BUTTON
OPPOSITE DIRECTION
BUTTON
5. On the wall control, press the opposite
direction button to make the carriers return to
the original starting position at 90° of the rail,
(open position) ( fig. 4 ).
The first tilting limit has now been set.
4. You can now release the blue button .
TILTING MOTOR
BLUE BUTTON
6. Press and hold the red button until you reach
step 8.
7. Press the opposite direction button of the one
selected in step 3.
The slats will rotate to the opposite direction of
the first tilting limit that was set.
Press the stop button when the slat is aligned
and set to 0° of the track (fig. 5) *.
OPPOSITE DIRECTION
BUTTON
STOP BUTTON
TILTING MOTOR
RED BUTTON
8. You can now release the red button .
On the wall control, press the same direction
button as selected in step 3.
The other tilting limit has now been set.
DIRECTION
BUTTON