Vertilux VTi 6-710-VB-00110, Инструкция по программированию

Страница: 4 / 20

3
vertilux.com
© 2019. Vertilux, Ltd. All Rights Reserved. Last revised: February 2019.
Setting traversing limits
Before starting...
The 2 buttons (red and blue) on the traversing motor must be
unlocked (fig. 2) .
The buttons are unlocked when they “click” once pressed. If both
buttons or at least one is locked, follow the procedure to reset the
motor to factory default settings (pp. 8-9) .
The carriers must be aligned and spread out to approximately the
middle of the track so that not all the slats are stacked to one side.
To do this, remove the track
COVER, remove GEAR 1 and pull the drive
CHAIN manually until the carriers are approximately in the middle of
the track (fig. 3) .
Then place the GEAR back.
Fig. 3 . Motor side
GEARS
TRACK
COVER
DRIVE CHAIN
MOTORS
1
2
3
4
Fig. 2 . Limit setting buttons