LD-16 Door Operator - Modernization
Electronic Setup & Adjustment
October 2021 - 88420 v.1.0
59
Wiring
(continued)
Figure 53 - Remove Cover and Attach Ground Wires
3. Attach the previously installed door operator harness and the plugs in the COP to
the Door Operator Control Board. See Figure 54 on page 60.
If non-TKE system, remove the COP plugs from the 462AEMx harness and wire the
harness directly to the COP terminals.
See also:
•
Harness Assembly diagrams start on page A-8.
•
Serial Communications - TKE Legacy Control Systems on page 71.
•
Discrete Controller Interface on page 74.
Loosen 4 Screws to Remove Cover
Cover
Ground Wires
Ground
Screws
Cover Screw
Door Control
PC Board
COP Extension
462AENx
COP Adapter
462AEMx
CWIx
Board
COP
The 120VAC female plug receptacle powers the GFCI receptacle in the CTS
Harness Installation Overview
Содержание LD-16
Страница 1: ...LD 16 Door Operator FOR MODERNIZATION ...
Страница 95: ...APPENDIX ...
Страница 96: ...APPENDIX ...