122051C VERSATILE DEEP CLEANER 115V
2
Legend Brands, Inc.
FIRE HAZARD
Do not use to pick up flammable or combustible liquids,
such as gasoline, or use in areas where these liquids
may be present.
Do not pick up any type of hazardous dust or toxic
materials, including burning or smoking cigarettes,
matches, or hot ashes.
Use only as described in this manual. Use only
manufacturer’s recommended cleaning solutions and
accessory tools.
Excess foam can damage machine components. Add
defoamer to the recovery tank per instructions if needed.
To unplug, grasp the plug, not the cord. Do not pull cord
to unplug. Do not pull or carry by cord, close a door or
window on cord, or pull cord around sharp edges or
corners. Do not roll appliance over cord. Keep cord away
from heated surfaces.
Do not wheel machine up or down stairs.
Do not put any object into openings. Do not use with any
opening blocked; keep free of dust, lint, hair and
anything that may reduce airflow.
Do not use machine if not in proper operating condition.
Protect from freezing. Freezing may damage internal
components and will void warranty.
Do not use with water with over 3 grains per gallon (51
milligrams per liter) of hardness. Use with hard water
could result in the formation of mineral deposits inside
pumps and fittings. Damage caused by mineral deposits
will void warranty. Inquire with your local water utility
about water hardness, or have your water tested.
Use only to extract moisture. Do not immerse end of
vacuum hose in liquid.
Do not use as a dry vacuum. Dust particles will damage
the vacuum motors. Damage caused by dry vacuuming
will void the warranty.
To prevent the growth of mold and mildew inside the
tanks, always drain waste tank after use.
Do not modify machine from its original design. All
repairs must be performed by a qualified service
technician using only parts approved by Legend Brands.
GROUNDING INSTRUCTIONS
WARNING! Improper connection of the
equipment-grounding conductor can result in
a risk of electric shock. Check with a qualified
electrician or service person if you are in doubt as to
whether the outlets are properly grounded. Do not
modify the plugs provided with the appliance—if the
plugs do not fit the outlets, have proper outlets
installed by a qualified electrician.
This equipment is for use on a circuit or circuits having a
nominal rating no more than 120V and is factory-
equipped with a specific electric cord and plug to permit
connection to a proper electric circuit. Make sure that the
appliance is connected to outlets having the same
configuration as the plugs. No adaptor should be used
with this appliance. If the appliance must be reconnected
for use on a different type of electric circuit, the
reconnection should be made by qualified service
personnel.
CONTROLS
ON THE CONTROL PANEL (Fig. 2)
Includes two rocker-type switches to control the blower
and the heater/solution pump.
SETUP
1. Press release button to extend handle.
2. Release twist latch, slide recovery tank forward and
lift up. Set tank aside.
3.
Cleaning:
Add cleaning solution to water in bucket to
make 2 gallons total (max.) and pour into solution
tank.
4.
Plain water rinsing:
Add 2 gallons (max.) of plain
water to solution tank.
NOTICE
: Use a low-foam detergent to control foaming in
the vacuum system and keep moisture, carpet fiber and
other debris from being drawn through the vacuum cutoff
valve and causing damage to the vacuum motors.
Damage caused by moisture or debris will void the
product warranty. Foaming may also occur because of
residues left from previous cleanings. If this happens,
use a defoamer additive. We recommend the use of
Chemspec Crystal Defoamer (part no. 104177). Follow
defoamer manufacturer instructions for proper use.
5. Connect both hoses.
6. Plug into grounded outlet.
A
D
B
C
Fig. 2: Control Panel
Blower ON/OFF
Solution pressure pump and
heater ON/OFF
