22
20012301
Vermont Castings DVR28 Direct Vent Gas Fireplace
Hand-Held Remote Transmitter Operating Instructions
If you cannot read or understand these installation instructions, do not attempt to operate.
Introduction
This transmitter operating range is approximately 20 feet (6 m). The transmitter operates on one of 1,048,576 security
codes that are programmed into the transmitter at the factory; this transmitter operates on radio frequencies with non-
directional signals. The receiver for this transmitter is built into the AF-4000 MOD module.
��
ON H/L
OFF/CONTINUOUS
PILOT BUTTON
MODE
SET
Wall Clip
Slot
Battery
Compartment
FP1818
Skytech remote
9/07
Transmitter
On H/L
Button
Off
Continuous
Pilot Button
Mode Button
Set Button
FP1818
The transmitter operates on (2) 1.5V AAA batteries. It is recom-
mended that ALKALINE batteries always be used for longer
battery life and maximum operational performance.
Before using the transmitter, install the (2) AAA transmitter bat-
teries into the battery compartment. (Use caution that batteries
are installed in the proper direction.)
ON H/L
1
2
OFF
Continuous
Pilot
MODE
3
SET
4
Key Settings
1. ON H/L
— Turns unit to ON and operates
the flame control HI or LO.
2. OFF
CONTINUOUS PILOT — Shuts the unit OFF and acti-
vates the continuous pilot on
feature.
3. MODE
— Changes unit from manual
mode to thermo mode.
4. SET
— Sets temperature in thermo
mode.
�����
����
��� ����
1
2
3
4
7
6
5
FP1819
LCD display
9/07
LCD - Liquid Crystal Display
1. DISPLAY
Indicates CURRENT room temperature.
2. ° F or ° C
Indicates degrees Fahrenheit or Celsius
3. FLAME
Indicates burner/valve in operation
4. ROOM
Indicates remote is in THERMO operation
5. TEMP
Appears during manual operation
6. SET
Appears while setting the desired tem-
perature in the thermo operation
7. PILOT
Appears in the Continuous Pilot mode
