Vermont Castings A18CFLRN, Инструкция по установке и эксплуатации

Страница: 6 / 16

6 20003903
The Damper Stop provided keeps your damper from acciden-
tally closing during operation of your set.
This Damper Stop
must be installed onto your Damper at all times . NOTE: The
damper clamp is designed to hold the damper plate open 3
inches. However, the damper must be fully open when the
log set is in operation.
Install the Damper Stop onto the edge of the damper plate. At-
tach by securing the bolt provided to the damper plate with an
adjustable wrench. (Fig. 3)
If the Damper Stop does not fit, drill a 1/4” hole into the damper
plate and install an
anchor bolt with nut, at a 90 degree angle, so that the damper
plate will remain fully open.
The proper finished installation of the Damper Stop is shown in
Figure 4. If the bolt fails to block the damper in an open posi-
tion, the damper should be removed from the chimney.
To check your vent for proper drafting: Light a tightly rolled
newspaper on one end and place it at the inside front edge of
the fireplace. Observe the smoke and be sure the vent is prop-
erly drawing it up the chimney. If the smoke is drawn back into
the room, extinguish the flame and remove any obstruction until
proper venting is achieved. If that fails, check with a qualified
chimney sweep.
Damper Stop Installation:
For Use with All Other Fireplaces
Connection to Gas Supply
1) Place the burner pan in the fireplace. The burner pan should be located several inches from the back
wall, centered from right to left.
NOTE: This is for burner connection purposes only.
Exact burner placement will be covered on Page 8,
after all connections have been made.
2) Attach the Gas Supply Fitting onto your
fireplace’s gas supply pipe, as shown in
Figure 5a or Figure 5b.
3) Attach one end of the Flexible Gas Connector
to the brass Burner Inlet Fitting which has been
factory installed into the burner.
4) Attach the other end of the Gas Connector to
the flared side of the Gas Supply Fitting.
Remember to use pipe thread sealant or teflon
tape only on the straight pipe threads. Do not
use on any flared ends.
DP104
Damper clamp
Harris
Figure 3
Damper
Plate
Damper
Stop
DP104
Figure 4
DP103
Damper clamp
Harris
Chimney
Clamp
Damper
DP103
CFM157
R-CFLR Gas Supply Connection
4/3/01 sta
Figure 5a
CFM157