Grounding
For outdoor installation, it is important to ground the installation to protect the
camera against electrical surges. The camera enclosure needs to be grounded
by connecting earth ground to the G pin on the connector block.
If you are using the VPOE-2 housing, refer to the VPOE-2 Housing installation
guide for grounding instruction. Otherwise, connect wire from the Earth
GND pin to the Earth ground connection to ensure the camera is properly
grounded.
In order to prevent a ground loop:
Use a BNC ground loop isolator in case the BNC video out is used
permanently.
For the FD and FDW models, do not connect Earth ground to the camera
power connector.
Do not use shielded Ethernet cables. If using a shielded Ethernet cable, the
shield should not be connected to the camera.
Powering with a 802.3at PoE Injector
This product is intended for indoor use and should be supplied by a UL listed PoE
power supply.
IP Camera Model
UL listed power supply required
V4320BX-DN
PoE 802.3af class 3 compliant
V4320FD-DN
PoE 802.3af class 3 compliant
V4320FDW-DN
PoE 802.3at class 4 compliant
► To power with a 802.3at PoE Injector
1. Plug a straight-through Ethernet cable into the RJ-45 connector on the back
of the IP camera.
2. Plug the other end of the cable into a PoE switch or to the Data&PWR port of
a PoE injector. If you use a PoE injector, make sure the Data port of the
injector is properly connected to the Ethernet switch.
Note
Routing of the Ethernet cable from the camera to the power source must be
done inside the building.
Chapter 1: Nextiva V4320 Series Overview
© 2014 Verint Systems Inc. All Rights Reserved Worldwide.
17
