A device in APIPA mode does not reside on the same subnet as the other
devices on the IP network. Therefore, it may not be able to view or be visible
by the other devices. All Nextiva devices use the following temporary APIPA
configuration:
IP address: 169.254.X.Y (where X and Y are based on the last two octets of
the MAC address of the device)
Subnet mask: 255.255.0.0
Gateway: 169.254.*.*
► To set a static IP address
1. Launch the Verint Camera Configurator.
2. In the
Discovery
tab, click
Device Search
.
3. From the
Discovery
table, right-click a device and select
Network Setup
.
Tip
To set a static IP address for multiple devices, press the
CTRL
key and
click each device.
4. From the
Network Setup
dialog, perform the following:
a. In the
Starting
box, type the IP address of the device.
b. In the
Subnet Mask
box, type the address specifying the subnet in
which the IP address belongs.
c. In the
Gateway
box, type the IP address of the server that acts as an
access point to another network.
d. Click
Apply
.
Chapter 2: Configuration
© 2014 Verint Systems Inc. All Rights Reserved Worldwide.
22
