Verint Nextiva S4200-2V-BZ, Руководство пользователя

Страница: 105 / 152

Verint Video Intelligence Solutions 99
Nextiva S4200 Series User Guide
Performing a Reset
Depending on the gravity of the situation, you can reboot the device or load its default
configuration if the device does not react the way is should:
1. Start by rebooting the device. The device will retain all its configuration.
2. If it continues to perform abnormally, load its default configuration. All user-defined
values will be lost.
To reboot the device:
1. Perform one of the following operations:
†
In SConfigurator, go to the Units tab, select the device to reboot, click Configure,
select the Unit entry in the parameter tree, then click Reboot Unit.
†
In the web interface, click Maintenance in the navigation pane, then click Reboot.
The device reboots, while retaining its configuration.
To load the default configuration:
1. Perform one of the following operations:
†
In SConfigurator, go to the Units tab, select the device to reboot, click Configure,
select the Unit entry in the parameter tree, then click Load Default Settings.
†
In the web interface, click Maintenance in the navigation pane. To keep the
network configuration, check Keep Network Settings. Click Load.
This operation assigns the factory default settings to the device (listed in Appendix A on
page 105). Following such a reset, you may need to reprogram the device (for instance, its
IP address and VSIP port) for proper operation within its network.
Recognizing the Status LEDs
The S4200 device comes with three bicolor (green-red) LEDs that provide detailed
information on the device activity. Each LED can go through three phases:
1. Warmup period if the internal temperature is too low
2. Bootup
3. Normal operation
The three LEDs are:
„
LAN—For the Ethernet network (802.3) status:
Condition Indication
Warmup
Red blinks (2.0 sec. intervals) The internal temperature of the device is too low.
Bootup