Verint Nextiva S1100, Руководство пользователя

Страница: 42 / 107

3: Configuring and Installing the Device
30 Verint Video Intelligence Solutions
Status LED
The system status LED is a bicolor (green-red) LED providing detailed information on the
current state of the device.
The following power-up conditions on the system status LED are abnormal:
„
LED not lit—Check the power supply and cabling. If power is available and the LED
stays off, call Verint Video Intelligence Solutions customer service for assistance.
„
Steady red LED persisting more than 10 seconds—There is an internal error that
prevents the device from starting normally. Power down the device, wait 30 seconds,
then power it up. If the condition persists, call Verint Video Intelligence Solutions
customer service.
„
Flashing green-red LED not during a firmware update—The device requires a new
firmware with a serial connection.
Condition Indication -T -R
Green blink every sec. The device is looking for a frequency channel.
3
Steady red for 5 sec. The device is powering up.
3 3
Flashing green (3 sec.
intervals) The firmware has started, but RF communication is not
established.
3 3
Flashing green (1 sec.
intervals) The firmware has started, RF communication is established,
but no video is transmitted.
3
The firmware has started, RF communication is established,
but no video is received.
3
Flashing green (0.2 sec.
intervals) The firmware has started, RF communication is established,
and video is transmitted.
3
The firmware has started, RF communication is established,
and video is received.
3
Three consecutive red blinks
every 2 sec. No video source is detected and no video is transmitted.
3
Flashing green-red (1 sec.
intervals) The device is undergoing a firmware update or is in backup
mode.
3 3
One red blink A video packet is lost. In the worst case, it could flash at
5 Hz.
3