Verint Nextiva S1100, Руководство пользователя

Страница: 38 / 107

3: Configuring and Installing the Device
26 Verint Video Intelligence Solutions
The corresponding receiver side is:
For a two-wire, half-duplex RS-485 connection:
1. Use the following wiring scheme on both devices:
2. Set the operating mode to RS-485 2 Wires and the line driver to RS-422 (for details,
see page 37).
RS-232
For an RS-232 connection, use the following wiring scheme to plug the device to the
peripheral, using the DB-9 connector on the CAB9P cable:
The numbering of the pins on the DB-9 connector is:
Cable Peripheral
Signal name Wire pair Wire color Signal name
Data+ green/black green Data+
Data- black Data-
Signal ground brown/black brown Signal ground
Signal ground black Signal ground
DB-9 pin number Cable signal name
2 RxD
3 TxD
5 Signal ground
7 RTS
8 CTS
Status
Tx+ / Tx-
(yellow and black)
Signal ground
(brown and black)
Power (red and black)
Rx+ / Rx-
(green and black)
Analog
monitor
Coax cable
Tx+ / Tx-
Signal ground
Target device (keyboard)