Verilink WANsuite 6450, Справочное руководство

Страница: 82 / 205

3-54 W A N s u i t e 6 4 5 0
NOTICE:
Setting the Target IP Address and Target IP Mask to 0.0.0.0 defines the
default route for this unit. Because a unit can have only one default
route, if a default route is configured as a WAN route on the above
screen, the Gateway address configured on the 10/100 Ethernet screen
must be left blank. Likewise, if a Gateway is configured on the 10/100
Ethernet screen, it becomes the default route, and no WAN default route
can be configured on a Static Route.
Next Hop IP Address: IP Address of the next device in the route.
Cost Cost of using that route.
Values: 0
−
65535
Default: 1
Route Status Indicates whether or not the current route is enabled.
Values: Enable, Disable, Enable and Advertise
Default: Enable
The Route Details screen provides the following user-activated buttons:
Dynamic Route Table Screen
Access this menu by clicking on “Dynamic Route Table” on the Static Routes
menu. This table shows both dynamic and static routes. Please note that not
all parameters are necessarily defined, depending on whether or not the routes
were learned dynamically. Primarily, the most useful information is included
in "Destination," "Interface Index," and "Mask" columns.
Figure 3.46 Dynamic Route Table Screen
Destination Network to be reached.
If Ndx Interface internal number.
Next Hop IP Address used to reach the destination network.
Button Function
Submit Sets any values that have been changed.
Static Route Table Returns you to the previous screen.
Delete Route Deletes the route currently displayed.