VeriFone Omni 3200M, Руководство по установке

Страница: 30 / 41

25
Omni 3200M Installation Guide
Printer Does Not Work
1. Check all terminal power connections. The integrated
printer receives its power directly from the Omni 3200M
terminal. The green LED indicator light in the upper left
corner of the terminal should be on.
2. If the green LED indicator is blinking off and on, the
printer is out of paper. Remove the paper roll cover and
install a new roll of printer paper.
3. Perform a power-on printer test to make sure the
integrated thermal printer is operating properly. For a
description of this procedure, see “Performing a Power-On
Printer Test” on page 21.
4. If the problem persists, contact your VeriFone distributor
or service provider.
Printer Paper is Jammed in the Feed Mechanism
1. Remove the paper roll cover. Then, lift up on the small red
lever located on right side of the paper roll cradle until it
snaps into its “up” position (see Figure 15). This lets you
move the paper freely through the paper feed mechanism.
2. Carefully cut the damaged paper from the paper roll and
clear the remaining paper from the feed mechanism.
3. Lower the paper release lever until it snaps back into its
“down” position.
4. Re-install the roll of printer paper. If the problem persists,
the problem may be due to poor paper quality. Install a
new roll of higher-quality paper.