VeriFone Omni 3200M, Руководство по установке

Страница: 26 / 41

21
Omni 3200M Installation Guide
5. If necessary, hold down the paper feed button until about
5 centimeters (2 inches) of paper emerge from the slot
below the serrated metal tear strip.
6. Insert the orange plastic spindle into the hole in the paper
roll you are holding. Then, place the spindle and roll into
the paper roll cradle so the ends of the spindle rest
securely in the two slots.
7. Replace the paper roll cover by inserting its two front tabs
into the slots on either end of the serrated metal strip and
then lightly pushing down on the back of the cover until it
snaps into place.
(Remember to lift up the end of the paper roll when
replacing the paper roll cover so that the paper rests on top
of the cover.)
Note:
The integrated printer has a paper feed release lever that
lets you manually adjust the position of the paper you have
loaded into the printer (see Figure 15). To do this, lift up on the
small red lever located on the right side of the paper roll cradle
until it snaps into its “up” position. You can now freely move
the paper up and down through the feed mechanism. When the
paper is in the correct position, lower the lever until it snaps
into its “down” position.
Performing a Power-On Printer Test
When you have installed a paper roll, you can perform a quick
test to make sure the printer is operating correctly:
1. Temporarily disconnect the terminal from its power source
by removing the power connector from the power port on
the back panel. (Twist the connector to the right to unlock
it and then pull it straight out.)