www.venuelightingeffects.com
TROUBLE SHOOTING
Problems
Reasons
Remedy
Power indicator light
off and no laser
Check if AC power matches
specified
Make sure of the specified power
or check the power facility
Set to Stand Alone mode
(Stand Alone Sound Active or
Stand Alone Auto)
Set to Slave mode by mistake
Via Stand Alone mode:
power indicator light
on, no laser
Via M/S mode, Slave
projector not working
properly
Via DMX mode, DMX
indicator light off and
no laser
Via DMX mode, DMX
indicator flicker,
but out of control of the
console.
Some patterns are
blocked
1. The mode setting (only
one Master with others
set as Slave)
2. Check if there is DMX
console or not
3. Check the connection
between Master and Slaves
1. Check if the work mode is
set to DMX mode
2. Check the XLR-XLR cable’s
connection and quality
1. Set the work mode properly
2. Disconnect with the DMX signal
3. Confirm the connection between
Master and Slaves
1. Set the work mode to DMX
mode properly
2. Replace XLR-XLR cables if
necessary
Set the console’s channel
distribution and the laser’s DMX
address again.
Make sure the DMX console’s
channel distribution matches with
the laser’s
--------------------
Power on again and the system
should correct itself
If any other problems occur, please contact your dealer.
8129.01 Venue PP laser Instr.indd 7
5/2/08 6:09:26 PM
