Venturo HT25KX, Инструкция по установке и эксплуатации

Страница: 26 / 48

SUPERCEDES
TITLE DATE
SECTION
CINCINNATI, OHIO
MFG., INC.
20415A
C200
2-10-03
7-25-03A
INSTALLATION DWG
RADIO REMOTE CONTROL
REMTRON RADIO REMOTE CONTROL
(20410, 20412 & 20414)
INSTALLATION
Mounting locations:
On-crane mounting:
For cranes without the “In-Compartment Controls” option, where the pendent/receiver connector plugs
into a connector mounted on the crane housing, the receiver must be mounted directly on the crane as
follows.
The ET10KX model without “In-Compartment Controls” requires the radio to be mounted on the
rear of the crane housing with the cable and antenna facing downward as shown. Mounting
the radio in this location will obscure several decals. Replacement decals (decals 15390A
instructions, 15391B warning, 15392 warning) have been included in the retrofit kit and should
be installed as close to the original locations as possible.
The HT40/50KX model without “In-Compartment Controls” requires the radio to be mounted on
the right side of the crane’s rear cover with the cable and antenna facing downward as shown.
Receiver
Receiver
• The master disconnect
(power) switch must be turned
off when the crane is not in use!
Leaving the power on when not
in use may result in dangerous,
unintentional activation of the
crane functions.