Venturo ET10KX, Инструкция по установке и эксплуатации

Страница: 31 / 64

SUPERCEDES
TITLE DATE
SECTION
CINCINNATI, OHIO
MFG., INC.
900530d
C200
5-30-90
10-23-97A
INSTALLATION DWG
ET10KX
MAINTENANCE
Crane requires only periodic lubrication. As a standard procedure this can be done at the
time the vehicle is serviced. Rotation bearings are self - lubricating. Fill Winch & Rotation
Gear Boxes to level of the side plug with S.A.E. 85W/140 Hypoid Lubricant.
Chains should be oiled lightly (DO NOT GREASE). Excess oil or grease will collect road grit
and cause excessive chain wear. Moly filled chassis grease should be applied by pressure
grease gun to fittings on each end of rotation worm shaft and on rotation gear teeth thru port at
rear of crane.
Fill electric hydraulic boom elevation, power unit reservoir to oil level line with boom down.
Use Automatic Transmission Fluid Type "A" or Type "B" (Dexron). Below 20 degrees F. add
3/4 pt. Kerosene. Drain and refill with Dexron ATF when weather warms up. Check
periodically or when boom action slows down.