Venturo ET10KX, Инструкция по установке и эксплуатации

Страница: 28 / 64

SUPERCEDES
TITLE DATE
SECTION
CINCINNATI, OHIO
MFG., INC.
CRANE OPERATION AND MAINTENANCE INSTRUCTIONS
ET8K(X), ET10KX, ET12K(X)
SAFETY
Before operating this crane, read and understand these instructions, the 850711 Crane Safety and
Hazards Information Sheet, and review all safety & instruction labels on the crane.
CRANE INSPECTION
Before operating this crane, inspect for wear, damage, or oil leakage. After the wire rope has been
run out, check for wear, kinks, and broken strands. Check the hook and safety latch for damage.
Correct any problems before using the crane.
CAPACITY
Before operating this crane, review the capacity diagrams on the 891014 Capacity Information Sheet
as well as the capacity charts on the sides of the boom to relate the load to be lifted to the boom
length and angle. The boom angle is shown by a gravity arrow.
SNATCH BLOCK
If the load exceeds 1600 lbs. for the ET8K(X) and ET10K(X) or 1750 lbs. for the ET12K(X) or if
reduced winching speed for better control of smaller loads is required, use the snatch block to rig
the crane for two part line operation. Refer to drawing 21701, 17450 or 21575 for this.
CONTROLS
This crane is operated by a remote control pendant. The pendant should be unplugged and stored
in a compartment or the cab when the crane is not in use.
Before plugging the pendant in, inspect the plug, socket, cord, pendant head, and switches for
damage. Actuate all four switches both ways to verify that they all have the same feel and sound
and that they return to the center position.
Plug the pendant into the socket on the right side of the crane and snap the strain relief tether to the
crane housing.
Turn on the Master Disconnect Switch. Use "Winch Down" to release tension on the wire rope to
unhook it from storage tie down position.
Use "Boom Up" to elevate the boom from the boom rest position.
Check all control functions to see that they are working correctly.
900530a
C200
7-27-06D
8-2-06E INSTALLATION DWG
ET8/10/12K(X)