Venturo ET10KX, Инструкция по установке и эксплуатации

Страница: 30 / 64

SUPERCEDES
TITLE DATE
SECTION
CINCINNATI, OHIO
MFG., INC.
900530c
C200
5-26-06C
5-27-06D
INSTALLATION DWG
OVERLOAD ALARM SYSTEMS (OPTIONAL)
This crane may be equipped with an optional overload alarm system.
1. Overload alarm horn sounds if rated load is exceeded at any reach.
2. If alarm sounds, RAISE Boom or LOWER Winch to remove overload.
3. Always RAISE Boom slightly before lifting load - Warning system INOPERATIVE when
cylinder is completely bottomed.
4. Alarm can be tested by raising Boom against UP limit stop.
MANUAL TELESCOPIC BOOM
The 6' to 14' and the 7' to 15' boom have a 4' manual telescoping section in addition to the 4'
power extension. A toggle pin locks the boom into either the extended or retracted position.
TRUCK SETUP & OUTRIGGERS
1. The truck should be parked on ground that is as level and as firm as possible when using
the crane.
2. The center of the crane should be positioned close enough to the job so that it can be
operated at a reach that puts the load within the rated capacity of the crane.
3. Set the vehicle parking brake and put the vehicle transmission in "park" or a low gear
unless the engine is to be left running.
4. Deploy the outriggers to help stabilize the vehicle against rocking or overturning when lifting
with the crane.
PREPARATION FOR TRAVEL
1. Return the outriggers to the stowed position. Install and secure all pins.
2. Stow the crane boom in the boom support.
3. Hook the winch line to a tie down point on the body or pedestal and apply tension.
4. TURN OFF THE MASTER DISCONNECT SWITCH.
5. Unplug the control pendant and store in a body compartment or the cab.
• The pendant (or receiver) plug must be un-
plugged from the crane socket and the Master
Disconnect (power) switch must be turned "off"
when the crane is not in use! Leaving the pendant
(or receiver) connected and the power on when
not in use may result in dangerous, unintentional
activation of the crane functions."
ET8/10/12K(X)