SPREADER SETUP & INSTALL KITS
Setup - 27
SS575 Drop Curtain Kit
Tools Required:
7/16” wrench & socket
1/2” wrench & socket
ratchet
9/16” wrench & socket
utility knife (SS575)
drill (SS575) 13/32” drill bit (SS575)
Before making repairs or adjustments set the parking
brake, turn off engine, and remove ignition key.
Always disconnect the negative battery cable from the
battery when working with electrical components. Always
work in a manner that does not put safety at risk!
Safety glasses must be worn during installation.
Ear (hearing) protection must be worn when
using air or power tools.
Installation Time (estimated)
30
minutes
Installation Notes:
Right and left hand orienta
-
tion referred to in these instructions is determined
as if sitting on the tractor seat, facing forwards.
Attention
To prevent thread galling, hand tools and a thread
lubricant are recommended when tightening stain-
less steel fasteners. Do not use air or electric power
tools as this increases the potential of thread galling.
Drop Curtain Setup
1. On both ends of the drop curtain, install a side
drop curtain mount (A) on each side of the belting
and fasten with 3) 1/4” x 3/4” bolts, 6) 1/4” flat
washers, and 3) 1/4” lock nuts as shown below.
Torque to 75 in-lbs (8.5 Nm).
A
A
2. Install the curtain clamp bracket (B) on the
outside (smooth side) of the drop curtain and the
rear belting mount (C) on the inside of the drop
curtain. Install 2) 1/4” x 3/4” bolts, 4) 1/4” flat
washers, and 2) 1/4” lock nuts in the two outside
holes only. Torque to 75 in-lbs (8.5 Nm).
B
C
