VENTO MOTORCYCLES
Rev no.01/ page 38of 84
C L U T C H S H O E / M O V A B L E D R I V E N FA C E
REMOVAL DISASSEMBLY
Driven wheel disc assy. spring bush (6) clip circle 17
Clutch disc 1 fixing axes 13 /sliding pin 12 clutch side board 18
Nut 2 seal 7 /driven step less shifting disc 9 spring 19 /clutch mass 20
Clutch driving board assy. 3 rolling needle bearing 16 damper rubber 21
Spring holder bush 4 clip circle (5)/ball bearing 14 limiter 22 /pin shaft 23
Compression spring 5 rear transmission main disc 11 driving board bottom holder 24
ASSEMBLY: The assembly sequence is just reverse of removal.
NOTE:
•
When reinstalling clutch driving board assy., be sure to use new limiter and pin shaft, and ensure
stable connection.
•
When installing ball bearing and roller needle bearing, use some lubrication to ensure free turning,
without sticky, and then use circlip (15) in proper position.
•
Before installing driven step less shifting disc, cover the driven step less disc with 2 O-rings (8) and
assemble seal (l0).
Содержание Phantom R4i
