1
2
3
4
energy
comfort
M
O
D
E
L:
A
C
C
0
4
3
3
Y
YW
W
X
X
X
X
M
A
D
E
IN
C
H
IN
A
U
S:
J3
C
TE
0
2
A
B
A
SE
1
At
the thermostat, select the mode (Auto,
Heat, Cool, or Off).
Adjust
the setpoints to the desired setting.
Here,
at the base station, press the
corresponding button for 5
seconds. The LED will flash for
5 minutes.
Within
5 minutes of pressing
the button on the base station,
press the link button on the receiver for 3 seconds. The
LED on the receiver will flash twice.
1 4 7
RINGS
The base station will now remember your settings. You
may change these settings at anytime by repeating the
above steps.
Refer to Owner’s Manual for more details
COMMERCIAL PROGRAMMABLE THERMOSTAT
HUMIDITY
FAN
PROGRAM HOLIDAY
MODE
OVERRIDE
OUTDOOR
SET CLOCK
PLATINUM
eries
AUTO
I2:00
Su
Pm
H
EAT
C
OOL
72
74
Press and hold the same desired link button for another five seconds. When the LED
begins flashing rapidly, release the link button.
Press and hold the link button on the RF Wireless Module for three seconds. The RF
Wireless Module’s flashing LED will indicate the status:
2 flashes indicate the unlink was successful.
10 flashes indicate a communication problem or the RF Wireless Module was not
linked to the Base Station.
Press the desired link button (Comfort or Energy) for five seconds. When the LED
begins flashing red, release the link button.
Notes on the unlinking procedure
After the unlinking process is complete, the Base Station’s LED stops flashing
The unlink mode remains active for five minutes
The unlinking procedure may be cancelled by pressing the Base Station’s link button
(Comfort or Energy) while its LED is flashing red
Side View
If it becomes necessary to unlink the thermostat(s) from the Base Station,
follow these steps:
Page 11
Installation & Setup
cont.
