1
2
3
4
energy
comfort
M
O
D
E
L:
A
C
C
0
4
3
3
Y
YW
W
X
X
X
X
M
A
D
E
IN
C
H
IN
A
U
S:
J3
C
TE
0
2
A
B
A
SE
1
At
the thermostat, select the mode (Auto,
Heat, Cool, or Off).
Adjust
the setpoints to the desired setting.
Here,
at the base station, press the
corresponding button for 5
seconds. The LED will flash for
5 minutes.
Within
5 minutes of pressing
the button on the base station,
press the link button on the receiver for 3 seconds. The
LED on the receiver will flash twice.
1 4 7
RINGS
The base station will now remember your settings. You
may change these settings at anytime by repeating the
above steps.
Refer to Owner’s Manual for more details
Side View
At the Base Station, press the Comfort Settings link button for five seconds.
The green power LED next to the button will turn red and flash for
up to five minutes.
Go to the thermostat, making sure that it is still set to your Comfort Settings.
Within five minutes of pressing the link button on the Base Station, press the
link button on the side of the RF Wireless Module for three seconds. The
LED on the RF Wireless Module will flash indicating the following:
2 flashes indicates that the link was successful
5 flashes indicates the communication was good, but the
thermostat was not in the appropriate mode; only
Auto, Heat and Cool are supported
10 flashes indicates a communication problem
After two flashes on the RF Wireless Module, the Base Station will remember
your Comfort Settings. You may change these settings at anytime by
repeating the above steps.
Link Button
LED
4
3
4
Page 7
COMMERCIAL PROGRAMMABLE THERMOSTAT
HUMIDITY
FAN
PROGRAM HOLIDAY
MODE
OVERRIDE
OUTDOOR
SET CLOCK
PLATINUM
eries
AUTO
I2:00
Su
Pm
H
EAT
C
OOL
72
74
3
Installation & Setup
cont.
