Vendo VARI-PAK 450, Руководство пользователя

Страница: 51 / 113

PG-18
07/2003
PG-19
07/2003
Custom Message
This feature provides the customer the ability to customize their welcome message on the
vending machine. The display has a 20-character capacity on two lines for a total of 40
characters. The message will not be shown if the feature is disabled.
To set the custom message
• Press selection button #4 when the display reads Custom Message.
•
The display will read
Enable X.
• Enable On = Custom message will be displayed.
• Enable Off = Custom message will not be displayed.
•
To change the status, press selection button #4.
• Press selection button #2 (up) or selection button #3 (down) to toggle between On/Off .
•
Press selection button #4 to save the change.
• Press selection button #2 at Enable X and the current message will be displayed.
• Press selection button #4 to change the current message. “ a “ will be displayed if no
previous message had been set.
• Press selection button #2 (up) or selection button #3 (down) to cycle through the available
characters.
• Press selection button #4 to save the character and advance to the next character. By
default, every other position will change to “a” during the programming. This is because
the lower case “a” is located in a central location between all usable characters.
• Usable characters – “!”#$%&’()*+,-./0123456789:;<=>?@ABCDEFGHIJKLMN
OPQRSTUVWXYZ[\]^_`abcdefghjklmnopqrstuvwxyz{|}~”
• Selection button #1 will be used as a space bar unless it is pressed and held for 2 seconds.
After the 2 seconds, the unwanted space will go back to the value that was there and the
message will be saved.
• Pressing selection button #1 will also return to Custom Message.
Return
Exits the programming mode and returns the machine to stand-by.
• Press selection button #4 when the display reads Return . The control board will be in an
open door standby mode until the door switch is activated