Vendo VARI-PAK 450, Руководство пользователя

Страница: 107 / 113

T-6
07/2003
T-7
07/2003
Inlet Sensor Machine’s coin inlet
sensor is blocked for
more than 1 minute.
Check changer harnessing for
cut, pinched or crimped wires.
Replace harnesses or
changer.
Escrow Return
Mech.
3 successive coins are
detected at the inlet but
do not make it into the
changer in 10 seconds.
Check inlet for blockage. If
nothing is found, check changer
harnessing for cut, pinched or
crimped wires.
Clear blockage or replace
harness or changer.
Cabinet Switch Cabinet (inner) door has
been open for more than
one hour.
Check the cabinet switch to see
if it’s sticking or miswired.
Replace the cabinet switch, if
defective.
ERROR PROBABLE CAUSE CORRECTIVE ACTION
Coin Acceptance/Payout (Record all errors for reference if Vendo Technical Service is required)
Coin mechanism will not
accept coins.
No power to control board. Check to make sure the red LED on the control
board is flashing red. If flashing, check MDB
harness connections. If connections are good,
replace changer.
Harness from coin mech to board is
cut or disconnected.
Use a meter and check each wire for continuity
and ground.
Short in coin mechanism. Replace coin changer/acceptor.
Acceptor is dirty or other problem
may exist (not tuned).
Clean acceptor or contact your local coin mech
dealer.
Defective control board. Replace control board.
No acceptance or rejects
a percentage of good
coins.
Coin return lever pressing down on
acceptor’s coin plunger.
Make sure changer is mounted correctly and the
coin return lever is in the proper position.
Acceptor is dirty or foreign matter is
in the path.
Clean acceptor or contact dealer.
Coin changer is improperly tuned (if
tunable).
Contact manufacturer for tuning.
Defective controller board. Replace/test controller.
Always accepts coins but
gives erratic/no credit.
If NO CREDIT: Defective harness
between coin mech and control
board (will have “CC” error).
Check harness for cut wires or wrong/bad
connections. Test each wire for continuity or test
to ground. If found to be defective, replace.
If ERRATIC OR NO CREDIT:
Acceptor or coin mech.
Replace coin mech and test.
If NO CREDIT: Defective controller. Replace/test controller.
Changer will not payout
coins.
Defective harness between coin
mech and control board.
Test vendor’s manual coin payout. If vendor
won’t pay out using the Coin Payout mode
or during sales, check harness for cuts, bad
continuity or wrong connections. If defective,
replace and test.
Defective coin mech. Replace coin mech and test.
Defective controller board. If coin mech won’t payout coins manually in the
Coin Payout mode or during the Sales Mode and
the above two procedures have failed, replace
the control board and test payout both in the Coin
Payout mode and during a sale.
Changer payout buttons are
disabled while door is closed or
while in Open-Door Sales Mode.
Enter the Service Mode or access the Coin
Payout Mode.