Velleman SPBS10, Руководство пользователя

Страница: 8 / 38

31.07.2014 ©Velleman nv
8
/$0!
Surface will be detected, but as surface is
located outside the detection range, it may
never be detected.
*$+ ,*%+-)-*%
Rough road conditions might trigger the
warning system.
•
Keep sensors clean at all times to ensure proper functioning.
•
Verify on a regular basis that sensors are still properly mounted.
•
Defective sensors should be replaced as soon as possible. Refer to an authorized dealer for
spar parts.
•
It is strongly advised to test the system before use.
G( -%$' ! )
!)!,)-*% ! )
Place an obstacle of ± 1m high at 80 to 100cm behind the rear bumper of your vehicle. Turn the
ignition to ON and put the car in reverse. The system should start to beep automatically or display
the distance to and the direction of the obstacle. Test the installed sensors individually.
$"%-%> ! )
Place an obstacle of ±50 x 50cm at 80 to 100cm behind the rear bumper of your car. Turn the
ignition to ON and put the car in reverse. The system should start to beep automatically or display
the distance to and the direction of the obstacle. Vary the distance of the obstacle to the vehicle
by moving it forwards and backwards. The system should now beep at different intervals and
meanwhile display the distance to and the direction of the obstacle. Move the obstacle left and
right: again, the system should beep automatically and display the distance to and the direction of
the obstacle.
H( !,/%-,$' 0!,-.-,$)-*%
working voltage 10<16VDC (via reversing light)
rated voltage 12Vdc
rated current 120mA
Dimensions
LCD<housing 85 x 53mm
LCD 60 x 40mm
control unit 98 x 70 x 25m
warning modes sound, ddibar graph on display
detection range 0.3 < 2m
max. alarm distance 2m
sensor angle H 60°, V 60°
ultrasonic frequency 40KHz±1KHz
working temperature <30°C to +70°C
for vehicle width up to 1.8m