31.07.2014
5
(
!$)&"!
•
detection of obstacles when the vehicle is put into reverse
•
beeps accelerate as the vehicle approaches the obstruction
•
long detecting distance: up to 2m, high stability
•
stable LCD with built<in buzzer, showing accurate distance to and directio
•
4 black waterproof build<in sensors with a large beam angle for a minimiz
•
installation height: 50<80cm
•
consists of:
o
1 electronic control unit with 1m power cable
o
digital colour LCD with built<in buzzer & 6m cable
o
4 ultrasonic sensors with 2.5m cable each
o
user's manual, double<sided adhesive tape, 2 quick<on ca
•
spare parts: sensor (SPBS10/SENS)
:(
1!"1-!5
Refer to the illustrations on page
6
of this manual.
Control unit
microprocessor<controlled
Power connector
6
Display connector
7
Sensor connector (4x)
Reverse light circuit
Power is drawn from the cars’ reverse li
Sensors
4 ultrasonic sensors
Liquid Cristal Display
With buzzer. When the car reverses, thi
of obstacles via audio + display of direc
the obstacle.
Sensor indication
Indicates which sensor detects the obsta
Distance value
Distance to closest obstacle.
Sound on/off
STOP<Warning
Distance bar graph
Graphical indication of distance to closes
support
;(
% )$''$)-*%
Refer to the images on page
6
and
7
of this manual.
$00'4 0*5!" )* )/! 4 )!# 2!.*"! $'' ,*%%!,)-*% $"!
!% *"
•
Determine the location of the sensors on the bumper carefully, as the pr
the system depends on it.
beware that detection results might be affected when sensors are inst
bumpers.
•
Refer to the pictures on page
7
for the best horizontal and vertical posit
vehicle.
•
Also make sure no part of the bumper is blocking the view of the sensor
•
Mark the location of the holes on the bumper and drill the holes with the
(Ø21.0mm).
•
Remove all burrs from the edge of the holes.
•
Insert the sensors and cables in the holes. All sensors are identical but t
determine the indications on the LCD. Therefore it is important to moun
indicated in the illustration (A left, followed by B, C and D on the right).
•
Make sure the central axis of the sensor is perpendicular to the bumper
necessary, first slide an included washer over the sensor.
The sensors can be repainted to match the colour of the bumper. How
the paint layer may not exceed 0.1mm!
©Velleman nv
ction of obstacles
imized blind area
n cable clips and hole saw
se light circuit.
, this unit warns the driver
irection of and distance to
bstacle.
losest obstacle.
$"! #$+!(
e proper functioning of
installed in steel
osition. L=width of the
nsor.
the included hole saw
ut their location will
ount the sensors as
ht).
per surface. When
However, the thickness of
Содержание SPBS10
Страница 2: ...31 07 2014 Velleman nv 2...
Страница 3: ...31 07 2014 Velleman nv 3...
