Velleman ED21120, Руководство пользователя

Страница: 3 / 26

CS120_v2 VELLEMAN 3
CS120 – METAL DETECTOR
1. Introduction and Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying a Velleman product! With your CS120 metal detector, you can search for coins, relics, jewellery,
gold and silver just about everywhere. Main features are: discriminator to distinguish ferrous metals (iron, steel…)
from non-ferrous metals (silver, gold…), adjustable sensitivity, volume control, adjustable stem, waterproof search
coil (Ø 170mm), low-battery indicator and a 1/8" headphone jack. Your metal detector requires 1 x 9V battery (order
code:
6LR61C
, not incl.).
Please read the manual thoroughly before bringing this device into service. If the device was damaged in transit, don't
install or use it and contact your dealer. Damage caused by disregard of certain guidelines in this manual is not
covered by the warranty and the dealer will not accept responsibility for any ensuing defects or problems.
2. Preparation
•
Assembling the Detector
Assembling your detector is easy and requires no special tools. Just follow these steps:
1. Remove the fixation system of the search coil (nut and bolt system). Insert the stem and align the holes on the
search coil bracket and the stem. Push the bolt through the holes and tighten with the nut knob.
CAUTION : Do not tighten the search coil fixation too hard. Do not use tools such as pliers to tighten it.
2. Insert the arm support into the end of the stem and tighten the lock screw at the back of the control housing.
3. Turn the stem’s lock nut clockwise until it loosens.
4. Adjust the stem length to have the search coil level with and about ½” to 2” above the ground when you stand
upright with the detector in your hand, your arm relaxed at your side.
5. Turn the stem’s lock nut counter-clockwise to lock it in place.
6. Wind the search coil cable around the stem. Leave enough slack in the cable. Insert the search coil’s plug into
the search coil jack on the detector’s control housing.
CAUTION : The search coil’s plug fits into the jack only one way. Do not force the plug or you could damage it.
7. Loosen the search coil fixation knob, adjust the search coil to the desired angle and tighten the nut knob.
•
Battery Installation
1. Make sure the detector is switched off.
2. At the back of the control housing, slide the battery cover off away from the middle.
3. Place a 9V battery in the battery compartment.
4. Slide the battery cover back on.
About batteries
- Use only fresh alkaline batteries of required size and voltage.
- Remove the battery when the device is not being used. Batteries can leak chemicals that can destroy
electronic parts.
Referencia Electrónica Embajadores: ED21120