CAMIP5
Rev.01
27.10.2010
©
Velleman nv
4
11.1
+5V DC output
11.3
alarm input
11.2
output (GND)
11.4
input (GND)
6.
Hardware installation and operation
•
Choose a location for the camera, keeping following guidelines in mind:
•
Do not install the camera in locations where extremely high or low temperatures or excessive
vibrations may occur.
•
Avoid mounting the camera near high electro-magnetic fields.
•
Do not aim the camera at the sun or other extremely bright objects.
•
The camera can be used free standing or in combination with the included mounting bracket. When
the mounting bracket is used, attach it to the wall or ceiling using the 2 included screws. Place the
CAMIP5
on top and secure it with the centre screw. Determine the desired angle and tighten the
joint screws.
•
Connect the antenna to the antenna connector
[7]
and/or connect a network cable (included) to the
RJ45 jack
[9]
.
Note:
it is possible to connect the camera straight to the RJ45 port of a computer. In this case a
crossed cable (not incl.) should be used and network settings must be configured manually.
•
Use of the alarm connector:
•
Connect an external alarm switch (e.g. a PIR sensor) to the alarm input
[11.3]
and the input
GND
[11.4]
. The
CAMIP5
can be programmed to handle events triggered on this input,
•
Connect an alarm output device (e.g. a buzzer) to the 5V DC output
[11.1]
and the output
(GND)
[11.2]
. In case an alarm condition exists, the output
[11.1]
will be high (5V DC).
Note:
the output can also be enabled with the
and
buttons in the ‘for operator’ window (see
further).
•
When desired, an external speaker system can be connected to the audio output
[8]
.
•
Plug the DC connector of the power adaptor into the 5VDC input jack
[12]
. Only use the included
adaptor or one with the same specifications.
•
Plug the adaptor into a suitable mains outlet (100~240V AC/50~60Hz).
Notes:
•
It takes about 30s for the camera to initialise.
•
During initialisation the camera will start moving to test the pan/tilt functionality.
•
When the image appears out of focus, turn the lens
[3]
to adjust.
7.
Software installation
•
Insert the included CD-ROM into a suitable computer system (not incl.).
System requirements: CPU
≥
2.06 GHz / memory
≥
256MB / network
≥
10 MB / video card
≥
64MB memory / recommended OS: Windows 2000 or XP / Mac.
Windows
•
Locate the software installer
IPCamSetup.exe
and double click it.