CAMIP5
Rev.01
27.10.2010
©
Velleman nv
15
•
Incorrect user or password.
Make sure to enter the right user name and password.
•
The sender is denied by the server.
Check whether the user needs authentication.
•
The receiver is denied by the server.
Could be due to anti-spam settings of the server.
•
The message is denied by the server.
Could be due to anti-spam settings of the server.
•
The server does not support the authentication mode used by the device.
Try without authentication or use a different server (sender address).
FTP Service Settings
Note:
these settings only take effect when the option ‘Upload Image on Alarm’ is checked in the
‘Alarm Service Settings’ menu (see below).
•
Fill out all FTP server data. The port is usually set to 21.
•
Set the FTP mode to standard (PORT) or passive (PASV).
•
When desired, check the ‘Upload Image Now’ checkbox and set an upload interval (in seconds).
•
Press ‘Submit’ to store the data before performing an ‘FTP test’. A successful test will display ‘FTP
test succeeded’. Possible error messages are:
•
Can not connect to server.
Check FTP server address
•
Network error. Please try later.
Check network cabling and settings.
•
Server error.
Check the FTP server
•
Incorrect user or password.
Make sure to enter the right user name and password.
•
Can not access the folder.
Make sure the folder exists and your FTP account is authorized.
•
Error in PASV mode.
Make sure the server supports PASV mode.
•
Error in PORT mode.
If the device is behind a NAT (Network Address Translation) device, PASV mode must
be selected.
•
Can not upload file.
Make sure your FTP account is authorized.