CAMCOLD17
15/05/2009
©2008 Velleman
®
Components nv
5
6.
Installation
•
Choose the location for the dome camera, keeping following guidelines in mind:
o
Do not install the camera in locations where extremely high or low temperatures, high humidity,
water vapour or steam, dust or excessive vibrations may occur.
o
Avoid mounting the camera near high electro-magnetic fields as this will influence image quality.
o
Do not aim the camera at the sun or other extremely bright objects or reflections.
•
Fix the mounting plate (
4
) to the wall with 4 anchors (when applicable) and 4 screws. Note that
mounting will be easier when the transparent cover and plastic protective cap are removed
[1&2]
.
•
Connect the video connector
[B]
to a monitor (not incl.) or a sequential switcher/quad splitter (not incl.)
when connecting multiple domes.
•
When using an RS485 controller (not incl.) and/or DVR (not incl.), connect the white wire
[A]
of the
camera to the ‘+’ and the green wire
[A]
to the ‘-’ of the RS485 controller and/or DVR.
•
Connect the power connector
[C]
to the included 12VDC power adaptor. Plug the other end of the
adaptor in the mains.
Note:
only use the included power supply.
•
Manually adjust the focus by rotating the lens
[3]
. Secure the position by rotating the ridged ring towards
the housing.
•
Re-install the plastic cover. Make sure the tabs snap into place
[2]
.
•
Place the transparent cover back and screw it clockwise. Make sure it is closed firmly.
7.
Technical specifications
camera
iris
auto
system
PAL
focal length
6mm
sensor
1/3" Sony colour CCD
back light compensation auto
number of pixels
582 (H) x 500 (V)
video output level
1.0Vpp / 75
Ω
, composite
horizontal resolution 420 TV lines
synchronizing system
internal
video S/N ratio
>= 48dB
gain control
auto
min. illumination
0.2 lux / F1.2
white balance
auto
IP rating
IP65
electronic shutter control auto
pan/tilt
communication
RS-485
pan angle
0° -200°
protocol
Pelco-P or Pelco-D
pan speed
12°/s
baud rate
2400, 4800 bit/s
tilt angle
0° - 90°
housing
aluminium
tilt speed
12°/s
ID number 1~9
controllable via IR remote
preset points
12 (10 normal, 2 auto scan)
ID number 1~64 controllable via Pelco controller
general
operating temperature 0 ~ 55°C
dimensions
180 x 140 x 140mm
power supply
12VDC/1A (not incl.)
weight
1150g
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product, please visit our website www.velleman.eu. The information in this
manual is subject to change without prior notice.
©
COPYRIGHT NOTICE
This manual is copyrighted.
The copyright to this manual is owned by Velleman nv.
All worldwide rights reserved.
No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without
the prior written consent of the copyright holder.