Veeder-Root TLS-RF Series, Быстрый старт

Страница: 9 / 26

6
Install and Configure Gateway
Gateway Mounting Bracket Installation
Refer to the label affixed to the Gateway for additional technical information.
Verify that, if applicable, the battery isolator is removed from the ATG’s backup battery prior to
Gateway installation. Failure to do so can result in the ATG being unable to successfully register the
Gateway.
1. Select a mounting wall nearest the storage tanks/forecourt to provide optimum reception. Once
the mounting wall has been determined, identify a position for the Gateway so the antenna will be
clear of obstacles and will not interfere with employee traffic. The Gateway antenna should be at
least 25.4mm (1") clear from any objects and be kept as far away as possible from electrically
conductive (in particular metal) objects. Avoid Gateway mounting locations which place metal
obstructions or sources of electromagnetic interference within the lines of sight between the
Gateway and Transmitters.
2. Get the mounting bracket (see Figure 3) and antenna from the Gateway installation kit. Locate a
position on the wall to attach the Gateway mounting bracket.
3. Hold the mounting bracket against the wall and mark the screw locations on the wall. Drill holes for
the screws and insert anchors. Place the mounting bracket over the anchors, using the bumpon
set if desired, and secure it with screws.