Veeder-Root TLS-RF Series, Быстрый старт

Страница: 7 / 26

4
Transmitter Board
Figure 2. Connecting Device and Power Cables to the Transmitter
LEGEND FOR NUMBERED BOXES IN Figure 2
1. Green LED (D7) – ON during a device
poll by the Transmitter
2. Red LED (D6) – ON when the radio is
sent data for transmission
3. Switch 2 DIP switches
4. Switch 1 DIP switches
5. Red LED (D8) – ON for 20 seconds
once the radio establishes a connection
with the Gateway. D8 will turn off within
20 seconds if the radio disconnects from
the Gateway and attempts to establish a
new connection.
6. Device input terminals (PWR and GND).
Observe polarity!
7. Power input terminals (PWR and GND).
8. Cable from Battery Pack – observe
polarity
9. Cable from surge protector
10. Cord grip bushing
11. Orient tapered bushing as shown when
attaching cord grips to Transmitter. Hand
tighten the cord grip nuts until the cables
are held firmly.
S1
S2
PWR GND PWR GND
BATTERY DEVICE
3
4
7
8
9
10
11
5
6
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
1 2
D8
D7 D6
J4 J3
Changing the DIP switch
settings should only be done
in consultation with Veeder–
Root Tech Support. Most
installations will not require
the DIP switch settings to be
changed from their default
positions.
The Transmitter LEDs will
turn off ~2 minutes after the
bright red D8 LED turns on to
conserve energy.