Veeder-Root TLS-RF Series, Быстрый старт

Страница: 23 / 26

20
5. Loosen the clamps installed in Step 4 on the back of the support bracket and slide the two clamps
down over the conduit. Position the support bracket so the tip of the antenna is about 25.4mm (1
inch) below the top of the sump, then tighten the two conduit clamps (see Figure 17). Insert the
Battery Pack into its support bracket cradle as shown.
Figure 17. Installing Support Bracket at Recommended Transmitter Antenna Position
6. Get the surge protector from the 330020–528 installation hardware kit and splice it in the cable
between the device (e.g. Mag Probe or Mag Sensor) and the Transmitter.
LEGEND FOR NUMBERED BOXES IN Figure 17
1. Top of sump 2. Battery Pack
25.4mm
(1”)
1
2