Introduction
This manual provides instructions to install, setup, and operate the components of Veeder-Root Pressure
Management Control (PMC) equipment. The PMC feature is an option for the TLS console platform, and as such,
many of the installation/setup/operation instructions for non-PMC specific tasks are covered in TLS-3XX supplied
literature. Do not use this manual when PMC is installed with ISD. Use the ISD Setup & Operation Manual,
577021-800.
Site Requirements
Below are the requirements for all PMC installations:
• V-R TLS-350R/EMC w/BIR, TLS-350 Plus/EMC Enhanced, TLS-350/EMC and ProMax consoles with ECPU2
- install as per TLS-3XX Site Prep manual, setup following instructions in TLS-3XX System Setup Manual.
• A flash memory board (NVMEM203) for PMC software storage - installed on the ECPU2 board in place of the
console’s 1/2 Meg RAM board - install as per TLS-350 Series Board and Software Replacement Manual, no
setup required.
• Smart Sensor Module and Vapor Pressure Sensor. Install and connect following instructions in the Vapor
Pressure Sensor installation Guide.
• Mod Bus module connected to a hydrocarbon sensor module installed according to processor manufacturers
specifications.
• An RS-232 Port will be available for use by contractor or government inspectors.
Contractor Certification Requirements
Veeder-Root requires the following minimum training certifications for contractors who will install and setup the
equipment discussed in this manual:
Level 1
Contractors holding valid Level 1 Certification are approved to perform wiring and
conduit routing, equipment mounting, probe and sensor installation, tank and line
preparation, and line leak detector installation.
Level 2/3 or 4
Contractors holding valid Level 2, 3 or 4 Certifications are approved to perform
installation checkout, startup, programming and operations training, troubleshooting
and servicing for all Veeder-Root Tank Monitoring Systems, including Line Leak
Detection and associated accessories.
ISD/PMC
This course of training includes In-Stations Diagnostics/Pressure Management Control
(ISD/PMC) installation checkout, startup, programming, and operations training. It also
includes troubleshooting and service techniques for the Veeder-Root In-Station
Diagnostics system. A current level 2/3 or 4 certification is a prerequisite for the ISD/
PMC course. After successful completion of this course the contractor will receive a
certificate as well as a Veeder-Root ISD/PMC contractor certification card.
Warranty Registrations
may only be submitted by selected Distributors.
Section 16
Pressure Management Control
16-1
