9
cc
1. Check that the wall and floor are vertical/horizontal and at right angles. If there are major height
differences, base your measurements on the lowest point of the floor. Bear in mind that there must
be room for fixed installations such as fridges/freezers, and that only plinth drawers with fully
extending Classic/Scala drawers are vertically adjustable, not plinth drawers with standard Integra
drawers. (Adjustment range for plinth legs is 135–173 mm, plinth height 150 mm). You must therefore
also measure the highest point in the kitchen. A laser tool can be useful here.
2. Fit a support bar (not included in the delivery from
Vedum) horizontally onto the wall. Use screws (not included
in the delivery from Vedum) that are suitable for the wall
material. (The wall bars normally sit at C-C 450 or 600 mm).
1.1 SUPPORT BAR FOR BASE CABINETS
1. Installing base and tall cabinets
NB: Where a plinth drawer or dishwasher is to be fitted, make a break in
the bar that is 25–50 mm wider than the plinth drawer/dishwasher.
3. Where a support bar is not used, supporting
legs must also be placed at the back edge of
the cabinets. Supporting legs are included at
the front as standard, and additional supporting
legs for positioning at the back must therefore
be ordered or agreed upon when placing
an order.
Fridge/
Freezer
Start from the lowest
point of the floor.
Start from the highest
point in the kitchen.