Vector Revolution 180, Руководство по эксплуатации

Страница: 91 / 151

Run
9
________________________________________________________________________________________
_______________________________________
9
-
38
If the retract distance reaches the axis limit, the head will automatically lift provided
none of the board sensor, convex sensor, bump bar or bump switch is activated at
the time (indicating the head is not clear of the panel). This should also be taken
into account when setting the panel positon.
CAUTION!
It is possible in some extreme circumstances for the head to retract sufficiently for
the board sensor, convex sensor and bump bar all to be clear of the panel but for
example for the trimmer to still remain close to part of the panel which could result
in damage if the head lifts.
It is the operators responsibility to ensure that the head will retract sufficiently to
clear the panel before lifting and to reposition the start position if this is likely to
occur.
It is also possible to stop the machine in EMERGENCY STOP if it appears that lifting
will cause damage to the head or worpiece. In this instance it is important to STOP
before the lift has commenced because once the head has lifted off its lower limit
switch, it will retract upwards on Emergency.
9.2.2 Saving start positions
On the control screen, there are two settable position fields (944 & 945). The current or
active field position is the one that is highlighted in red. It is possible to toggle between
the two settable positions by touching either field area (944 or 945). When the icon Move
to Position (942) is pressed, the machine will move until the actual position matches the
“current” target position (946).
The screen message (947) will state “Moving to position”. When all axes (X, Y and C) are
within their deadband range of this target position, the machine will cease moving and the
screen message will read “Start when ready”.
926
993
933
950
951
941
944
945
946
947
942
959
960
955