AVFRPS1
Front & Rear Parking System
5
The sensors are labelled A,B,C and D for both modules.
Please ensure that these are plugged into the corresponding ports on the module.
The display will connect to the front module as shown below.
The 2-pin plug is not used on either the front or the rear module.
Setting Up
Dip Switches
The dip switches should be set as follows:
Front Module:
Dip switch 1 ON
This determines whether the module is being used as a front or rear module.
Dip switch 2 OFF
This sets the unit to adjust the detection range by 20cm to account for tow bars or
spare wheels etc. This function is not active when the module is set to front mode.
Front Module:
Dip switch 1 OFF
This sets the unit up for rear operation.
Dip switch 2
If you have a tow bar or spare wheel mounted to the rear of the car then you may wish
to turn this function ON. It will then offset the detection point to 20cm away from the
rear bumper. This will allow the tow bar or spare wheel to be ignored and not cause
false triggering.
If you do not have any protrusion from the rear of the vehicle then you can leave this
switch set to OFF.
