VDO TR 7327 B, Руководство пользователя

Страница: 11 / 26

12
The headunit has been tested with the follow-
ing brands:
Kingston
Toshiba
Sandisk
The headunit will support USB devices for-
matted in FAT16 or FAT32 only. USB devices
formatted in NTFS fi le format may not read
correctly.
Notes on Bluetooth® Technology
Bluetooth is a short-range wireless radio con-
nectivity technology used mainly for mobile
phones, hand-held PCs and other devices.
Bluetooth SIG Inc. owns the Bluetooth word,
marking and logos; and any use of such
marks is under license. Other trademarks
and trade names are those of their respective
owners.
Bluetooth operates in 2.4 GHz frequency
range and transmits voice and data at speeds
of up to 1 mbps within a range of up to 10 m.
The headunit supports the Handset Profi le
(HSP), Handsfree Profi le (HFP) and Ad-
vanced Audio Distribution Profi le (A2DP).
The headunit has been verifi ed and certifi ed
by Bluetooth Qualifi cation Program (BQP) for
compliance to the Bluetooth standards. For
more information, please check the Bluetooth
web site (http://www.bluetooth.com/Blue-
tooth/Connect/Products/) for the BQP product
listing.
INSTALLATION
Use the supplied mounting sleeve and the
rear screw to mount the headunit fi rmly in the
dashboard. Only use the supplied screws for
installation. Keep leftover installation equipment
for future use. If the installation requires drilling
of holes or other modifi cations to the vehicle,
please contact your dealer. This headunit is de-
signed for the installation in the DIN-sized radio
space in the dashboard of your vehicle.
Connection
Connection in vehicles equipped with
standard ISO connectors
The headunit may be installed without major
preparation in vehicles with ISO connec-
tors. However, some signals may have to be
adapted or connected to the ISO connectors.
Ä
ð
ð
ð
Ä
Ä
Ä
Ä
Ä
Ä
Connection in vehicles without standard
ISO connectors
For vehicles with different connection require-
ment, ask your dealer for an adaptor cable. If
no adaptor cable is available for your vehicle,
connect the headunit as described in the
"Connectors" section.
Preparation
The device must be connected to a 12V DC
electrical system with a negative terminal to
earth (car chassis).
Warning:
Installation that does not conform
to these requirements may result in
malfunction, damage or fi re!
To avoid the risk of short circuit during instal-
lation, disconnect the negative terminal of the
battery until the headunit has been securely
installed and connected.
Connectors (fi g. H, I and J)
Connector A (fi gure H)
A4: Connect to the switched 12V supply
(switched on/off by the car ignition)
A5: Connect to the power supply for an elec-
tronic antenna or the control wire for the relay
of an automatic motorized antenna. Do not
use this connection for direct power supply to
the antenna motor.
(optional) A6: Connect to corresponding
dashboard wiring for the lighting control for
in-vehicle illumination.
A7: Connect to a permanent 12V supply.
This is the main power supply. Ensure that
this connection can handle a current of up to
15A.
A8: Connect to earth/ground (vehicle chassis
or negative terminal of the battery).
Pin Signal Pin Signal
[A1] - [A5] Antenna control
[A2] - [A6] Pilot Light
[A3] - [A7] Battery
[A4] Ignition [A8] Ground
Ä
Ä
Ä
Ä
Ä
Ä