Initial start-up
1. Reconnect the car battery.
2. Restore perfect functioning of the electrical system (clock, onboard computer, alarm
system, airbag, immobilizer, radio coding, etc.).
3. Switch on the ignition.
4. Insert map CD into the navigation computer.
5. Insert batteries (not supplied) in the battery compartment of the remote control (see
user manual of the navigation system).
6. Park the car so that the GPS antenna has free “visual contact” to the sky.
7. Start the engine.
The monitor display appears (user advice).
8. Confirm the user advice by pressing
OK
key on the remote control.
The start menu appears, initialization of the navigation computer then begins
(duration between 2 and 10 minutes).
Checking the car functions
A
Only check safety functions when the car is standing still or driving at low speed!
Always carry out checks in open areas!
Check brake system, alarm system, lights, immobilizer, speedometer, trip computer,
radio (coding) and hi-fi stereo, clock.
Checking the navigation functions
Check the following functions when the car is stationary:
Remote control
Put remote control in the holder.
The keys on the remote control must light up.
GPS reception
Enter a destination and select “Guidance”. Select info screen i3 “GPS position” and
check the number of received satellites. For sufficient positioning the number should
be between 4 and 8.
Calibration
Make a short test drive (approx. 10 minutes) on digitized streets for automatic
calibration. Change direction several times.
Cross different junctions and check the indicated position in info screen i1 “Car
position”. If the indicated position matches the true car position, calibration is
finished.
Hotline
For answers and questions concerning the VDO Dayton Navigation System there is a
Hotline available in many countries.
G
0121 344 5400
Q
1 800 335 282 Toll Free or (03) 94503166
MOUNTING INSTRUCTIONS
51
English
3112 316 0888.1 Neudruck
Donnerstag, 24. August 2000 11:01:50
Farbprofil: Deaktiviert
Komposit Standardbildschirm
